If you can’t seed winter wheat as soon as you would like, consider these recommendations
By Robert Klein, University of Nebraska-Lincoln Extension crops specialist
This year wheat planting may have been delayed, or replanting may be necessary due to grasshopper feeding or seed that wasn't placed at the proper seeding depth due to dry hard soils. Winter wheat seeded late can out-yield winter wheat seeded earlier, especially when compared with wheat planted much before the suggested dates. This yield increase can be attributed to reduced disease and insect problems and the use of extra soil water in the fall.
If you’re going to be seeding wheat late, you can increase your chance of success by taking these steps:
Use narrow row spacings. When seeding after the recommended date, narrow row spacings of 5-8 inches are preferred over wider spacings of 10-15 inches. If you use a wider spacing, such as with a 15-inch seeder, consider seeding twice, with the second pass at a slight angel to the first. Use one-half the seeding rate each time. This will only work with disc drills; hoe drills move soil and would bury much of the seed from the first pass.
Increase the seeding rate. Late seeding usually results in less root and tiller development. A general recommendation is to increase the seeding rate 10 to 15 lb. (150,000-225,000 seeds) per acre per week after the suggested seeding date for your area. The maximum seeding rate for rainfed wheat is 120 lb. (1,800,000 seeds) per acre or limit the maximum to about twice the seeding rate at the suggested date for your area.
For irrigated wheat the recommended seeding rate is 90 lb. (1,350,000 seeds) per acre if planted at the suggested seeding date. Increase the seeding rate 15 to 20 lb. (225,000-300,000 seeds) per acre for every week after the suggested seeding date to a maximum of 180 lb (2,700,000 seeds) per acre.
Also, when no-tilling into row crop stubble, seeding rates are usually increased by as much as 50% even when seeded during the suggested seeding dates. When seeding occurs more than one week after the suggested seeding date, the seeding rate should be 90 to 120 lb. (1,350,000-1,800,000 seeds) per acre for rainfed. With irrigated wheat, increase the seeding rate the same up to the maximum listed earlier.
Apply phosphorus with the seed. When seeding wheat late, phosphorus placed with the seed helps improve yield. Use 20 lb. phosphorus where none is called for by soil tests and increase other phosphorus rates which are over 20 lb. by 20% for late seeded winter wheat.
The normal superphosphates and ammonium phosphates generally have a negligible effect on wheat stands because of the low salt content of phosphorus fertilizers compared to nitrogen fertilizer, the low concentration associated with narrow rows (5-12 inches), and the generally high rates of seed used. The seeding mechanism for applying phosphorus fertilizer with the seed is not critical unless the producer applies additional nitrogen at the same time. Do not apply over 15-20 lb of nitrogen per acre with the seed. Also, do not use 12-0-0-26.
If equipment is not available to place fertilizer in the seed furrow, 11-52-0 or 18-46-0 can be mixed with the winter wheat seed. A good mix is important and fertilizer dealers can usually do this for you. I prefer to use 11-52-0 with its lower nitrogen content. With this method, check to see if you are satisfied with the mix by test drilling on top of the ground so you can observe how well the winter wheat seed and fertilizer are mixed. Be aware that with this method, the fertilizer may cause more wear to the drill. Also, fertilizers can absorb water so take precautions against this.
Use certified treated seed to increase planting success. The seed treatments need to thoroughly coat the seeds to give good results and should be applied with quality seed-treating equipment.