Sep 18, 2014
Home| Tools| Events| Blogs| Discussions| Sign UpLogin

In the Shop

RSS By: Dan Anderson, Farm Journal

As a farm machinery mechanic and writer, Dan brings a hands-on approach that only a pro can muster. Along with his In the Shop blog, Dan writes a column by the same name as well as the Shop Series for Farm Journal magazine. Always providing practical information, he is a master at tackling technical topics and making them easy for all of our readers to understand. He and his wife, Becky, live near Bouton, Iowa.

In The Shop: Sometimes I Get Too Fancy

Oct 27, 2010

 Having a respectable assortment of tools is good, but sometimes I get carried away and forget that fancy tools aren't necessarily better than simple tools.

For example, today I was installing a bearing and seal. I was frustrated and talking to myself because I didn't have a bearing/seal driver the exact size I needed for the job. Then I asked myself, "What did you do before you had a set of fancy (expensive) bearing/seal drivers, dummy?" After a vigorous head-slap, I grabbed a small wooden block, tapped the bearing and seal into place, and vowed to not become so enamored about having the perfect tool that I can't figure out a simple way to get the job done.

With that in mind, here's a short list of "innovative" ways I've got around not having the perfect tool for certain jobs. I'm not bragging, and I'm a little ashamed at some of the crude things I've done, but...

-for small motorcycle and ATV wheel bearings and seals, I've used various half-inch drive sockets as bearing/seal drivers. My 3/4-inch drive socket set is kind of battered because I've used the 2-inch and larger sockets as drivers for larger bearings.

-when I didn't have an ammeter available to check for faulty circuits that were dead-shorting a battery, I systematically pulled all the fuses for the machine, then then installed them one by one to find the shorted circuit. Duh. 

-when I needed a big allen wrench but didn't have the correct size, I used a hex head bolt upside down to fit into the allen-headed bolt, then gripped the bolt's shank with a pair of Vise-Grips to turn my impromptu allen wrench. On occasions when I couldn't find a hex head bolt that had the right size hex head, I ground the flats on a larger hex head bolt until that bolt fit into the allen head I was trying to remove.

-and I, uh, "know" of a mechanic who was in the field, needed a sledge hammer to knock apart a stubborn assembly but didn't have one, so he used a large rock on the end of a fencepost he liberated from a nearby fence to bludgeon things apart. 

Isn't it amazing how creative a person can be when he's tired, hungry, miles from home, and nobody is looking...



Log In or Sign Up to comment

COMMENTS (2 Comments)

Nebrfarmr - Comstock, NE
Hex-shank chisels & punches, sometimes ground down a bit make very good giant hex-key wrenches.
Also, the old locking collar makes a good bearing driver, as well, just be sure to orient it so that it isn't 'locked' when you hammer on it & that the set screw won't scratch the shaft.
8:17 PM Nov 7th
An old bearing not completly destroyed works to drive in a new bearing until flush.
7:18 AM Oct 28th

Hot Links & Cool Tools


facebook twitter youtube View More>>
The Home Page of Agriculture
© 2014 Farm Journal, Inc. All Rights Reserved|Web site design and development by|Site Map|Privacy Policy|Terms & Conditions