Aug 30, 2014
Home| Tools| Events| Blogs| Discussions| Sign UpLogin

$100 Ideas: Plow Edge for Uneven Surfaces

February 12, 2014
 
 

You can join our $100 Ideas Club!

Share your unpublished ideas and join our $100 Ideas Club. The Double Your Money winner receives $200. Other farmers featured receive $100 each.


$200 Double Your Money Winner!

Mid Feb2
 Jim Friend
Pepperell, Mass.

 

For approximately $30 in materials and three hours in the shop, Jim Friend was able to fabricate a rounded edge for his plow blade. Cutting the slot along the pipe was the most time-consuming step of the process. Jim used a cutting torch but says a plasma cutter would certainly be quicker. The simple retrofit is easy to slip on and off the plow blade. Jim, with help from his wife and daughter, raises beef cattle on Sunnyside Farms.

 

 

Plow Edge for Uneven Surfaces

Mid Feb

Around our farm, we have a lot of non-paved roads and barnyards to clear after snowstorms. If the ground isn’t frozen, the cutting edge of the plow blade gouges too deeply and creates an even bigger mess. I decided to retrofit my plow blade using a 2" steel pipe cut the length of the blade. I cut a slot in the pipe lengthwise and slipped it over the standard edge of the blade. I then welded a couple of steel straps with a hole in the end so the pipe can be bolted to existing bolts in the blade. The result: a 2" rounded cutting edge that can installed or removed in minutes.


Tire Jack Mount

100 ideas midFeb2014 2

Since our trailer is often away from home, we made a mounting bracket for a tire jack on the neck of the trailer. The jack foot rests in a "pocket" made from flat iron welded to the bottom of the trailer neck. Next, weld an all-thread bolt to the trailer that slips through the jack’s lifting holes. Make a homemade handle out of a small piece of pipe welded to a nut that will thread onto the bolt. Set the jack in the pocket, making sure the bolt goes through the hole, and tighten down the handle so the jack is secure.


Carson Tardy
Effingham, Ill.



Tarp Bow Deflector

100 ideas midFeb2014

Tarp bows on a semitrailer or wagon often deflect and spill grain when filling a truck that stops in the wrong spot. I added a 6"x8" piece of rubber belting around the tarp bow mounts to deflect grain back into the trailer where it belongs. When rolling the tarp back down, the rubber pieces are notched and flexible enough to fold flat.


Treg Shidler
Clay City, Ind.

 


To submit your unpublished idea, which must include a description, photo or sketch, address and phone number, write to $100 Ideas, Farm Journal, P.O. Box 1188, Johnston, IA 50131-9421, e-mail $100-Ideas@farmjournal.com or fill out the entry form at www.farmjournal.com/enter_100_ideas. Winners receive a hat and a check. All published material becomes Farm Journal Media property.

See Comments

FEATURED IN: Farm Journal - Mid-February 2014
RELATED TOPICS: $100 ideas

 
Log In or Sign Up to comment

COMMENTS

No comments have been posted



Name:

Comments:

Receive the latest news, information and commentary customized for you. Sign up to receive Dairy Today's eUpdate today!

 

MARKETS

CROPSLIVESTOCKFINANCEENERGYMETALS
Market Data provided by Barchart.com
 
 
 
The Home Page of Agriculture
© 2014 Farm Journal, Inc. All Rights Reserved|Web site design and development by AmericanEagle.com|Site Map|Privacy Policy|Terms & Conditions